Skip to Content

Revolution INVINCIBLE Stone Sealer — Maximum-Performance Water-Based Fluoropolymer Impregnator for Natural Stone

(0 review)
444.99 444.99
37.30
  • Brand
  • Size
Terms and Conditions
Brand: Revolution Stone Care

Revolution INVINCIBLE Stone Sealer — Maximum-Performance Water-Based Fluoropolymer Impregnator for Natural Stone

Revolution INVINCIBLE is a maximum-strength, natural-look impregnating sealer for all natural stone, formulated with the latest water-borne fluoropolymer technology to protect against the toughest oil- and water-based stains. It penetrates the stone and lets it breathe (proper air transmission) while leaving the natural appearance unchanged. Low odor, easy to use and environmentally safe, for interior and exterior use. Available in quart, gallon, 5-gallon and 55-gallon drum.

PropertyDetail
BrandRevolution Stone Products
ProductINVINCIBLE Stone Sealer
ChemistryWater-borne fluoropolymer impregnator
FinishNatural look (non-color-enhancing)
Coverage200–1,500 sq ft per gallon, depending on stone type and application method
Coats1–2 (second coat on porous surfaces 30 min after the first)
Dwell / penetration20–30 minutes, then wipe off excess before drying
Cure time24–72 hours (test area: full 24-hour cure)
Foot trafficMay begin after 5–7 hours (cover if used sooner)
Expected wearInterior 3–5 years; exterior 1–3 years with proper care
Application toolsLow-pressure pump sprayer, roller or paint brush
SurfacesGranite, marble, travertine, limestone, sandstone, slate, saltillo, terrazzo, clay products and grout
Use environmentInterior and exterior
OdorLow odor; environmentally safe
SizesQuart, gallon, 5-gallon, 55-gallon drum
  • Latest water-borne fluoropolymer technology for maximum stain protection.
  • Repels the toughest oil- and water-based stains while keeping the natural look.
  • Breathable — allows proper air transmission through the stone.
  • Low odor, easy to use and environmentally safe.
  • Rated interior 3–5 years / exterior 1–3 years of protection with proper care.

Make sure the surface is clean, dry and free of waxes and coatings, and let new grout cure at least 24 hours. Mask off adjacent areas, then apply a liberal, even coat with a low-pressure pump sprayer, roller or paint brush. Let the sealer penetrate, spreading any excess to ensure even coverage, and wipe off all remaining sealer before the surface dries. Apply a second coat on more porous surfaces 30 minutes after the first. Always test an inconspicuous area first (24-hour cure) to confirm the desired result. Do not aerosolize.

Wear appropriate PPE. Follow manufacturer instructions and safety regulations.