$ 9.09
$ 9.09
$ 9.09
AL30/40/50-02 Aardwolf Lifter 30/40/50 M16x10 Bottom Bolt
OEM Aardwolf replacement M16x10 bottom bolt for the AL30, AL40, and AL50 series slab lifters. This serviceable fastener restores secure clamp assembly contact and is part of routine preventive maintenance on Aardwolf manual stone lifters used throughout fabrication shops.
Always wear appropriate PPE. Follow local safety regulations when using power tools or chemical products.
- Part number: AL30/40/50-02
- Bolt size: M16 x 10 mm
- Brand: Aardwolf (OEM)
- Compatibility: AL30, AL40, AL50 slab lifter series
Manufactured to Aardwolf factory specification using hardened steel with appropriate corrosion-resistant finish. Drop-in OEM fit; no machining or modification required.
- Remove the lifter from active use and place on a clean bench
- Inspect the receiving thread for damage before installation
- Apply manufacturer-approved thread locker if specified in your maintenance manual
- Torque to manufacturer specification; do not over-tighten
- Inspect operation through a full load/release cycle before returning to service
Aardwolf recommends scheduled inspection of all lifter fasteners as part of routine preventive maintenance. Replace any bolt that shows visible wear, thread damage, or deformation. Keeping spares on hand reduces downtime on critical lifting equipment.